Cadence Flash F200-2 Guía para resolver problemas Pagina 67

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 504
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 66
Services switchover (OAM shell) 67
Services switchover (OAM shell)
This sections shows all commands that can be used for services
switchover.
soHelpMenu
Show commands you can use for Services Switch Over
soCmdStatusShow
Show service switch over commands status
Graceful disable commands
This section contains the graceful disable commands for the IP Line,
Virtual Trunk and Gatekeeper applications available from the OAM shell.
These commands do not interrupt established calls. Graceful commands
determine if available resources exist to reregister virtual trunks or IP
Phones and cause the virtual trunks and telephones to reregister only
when they are idle.
disServices
Cause the Voice Media Gateway Card (VGCM) or Signaling Server to
gracefully switch the registered resources to the other VGMCs or Signaling
Servers in the same node.
disVTRK
Cause the Signaling Server to gracefully switch the registered virtual
trunks to another signaling Server in the same node.
disTPS
Cause the VGMC or Signaling Server to gracefully switch the registered
line TPS to the other VGMCs or Signaling Servers in the same node.
disGK
Place the local gatekeeper out of service and the alternative gatekeeper in
service.
Force disable commands
This section contains the force disable commands for the IP Line, Virtual
Trunk, and Gatekeeper applications available from the OAM shell. The
force commands unregisters the virtual trunks and telephones, whether or
not there is somewhere for these resources to reregister, which may strand
the resources (for example, a telephone may have nowhere to reregister
and continuously reboots, or virtual trunks may be disabled so you cannot
make trunk calls with them). The force commands also cause active calls
to be torn down (a trunk call using a virtual trunk resource is dropped, and
a telephone on a call is reset.)
Nortel Communication Server 1000
Troubleshooting Guide for Distributors
NN43001-730 02.02 31 December 2009
Copyright © 2008-2009 Nortel Networks. All Rights Reserved.
.
Vista de pagina 66
1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 503 504

Comentarios a estos manuales

Sin comentarios