Cadence Flash F200-2 Guía para resolver problemas descargar pdf (Pagina 452)

100

101

452 Linux Base

Figure 10

hostconfig show

ifconﬁg

Syntax:

ifconfig interface [aftype] options | address

Ifconfig command is used to configure the kernel-resident network

interfaces. During system boot time it sets up interfaces as necessary.

This command can be used during debugging or when system tuning is

needed. ifconfig may be used to check if network interfaces are working

correctly, as well as to enable/disable interfaces, or to temporarily change

interface parameters.

If no arguments are given, ifconfig displays the status of the currently

active interfaces. If a single interface argument is given, it displays the

status of the given interface only; if a single argument is given, it displays

the status of all interfaces, even those that are down. Otherwise, it

configures an interface.

Useful options:

• Interface - The name of the interface. Currently eth0 used for ELAN

interface and eth1 used for TLAN interface.

• Up - This flag causes the interface to be activated. It is implicitly

specified if an address is assigned to the interface.

• Down - This flag causes the driver for this interface to be shut down.

• [-]promisc - Enable or disable the promiscuous mode of the interface. If

selected, all packets on the network will received by the interface. May

be useful for capturing packets.

• -a - Displays all interfaces.

Note: Use of this command will cause network service availability

interruptions. Do not use on live system other than during planned

maintenance windows.

Nortel Communication Server 1000

Troubleshooting Guide for Distributors

NN43001-730 02.02 31 December 2009

1 2 ... 447 448 449 450 451 452 453 454 455 456 457 ... 503 504

Comentarios a estos manuales

Sin comentarios

Cadence Flash F200-2 Guía para resolver problemas Pagina 452

Comentarios a estos manuales

Relacionado con productos y manuales para Amplificadores de audio de coche Cadence Flash F200-2