Cadence Flash F100-5 Guía de instalación descargar pdf (Pagina 7)

MOUNTING AND WIRING

MOUNTING THE AMPLIFIERS:

Choose a convenient mounting location with unobstructed airow.

The Flash ampliers feature four mounting tabs located at the ampliers four corners.

Using the supplied screws and grommets, gently mount the amplier in to position.

*** Do not over tighten the screws.***

REMOTE TURN-ON

terminal of head unit

FUSE

GROUND POINT

BATTERY

The Flash Series ampliers are supplied with built-in fuses, never replace the fuse that the amp

came with, with one of a larger value.

We suggest you construct a Red wiring harness with 2 additional fuses. One fuse should be

located near the car battery. This fuse near the battery oers protection against damage from

short circuits to the car chassis between the battery and the amplier. A second fuse closer to

the amplier oers additional safety to the amplier itself. This fused red power wire should be

attached to the amplier power terminal marked 12V+.

The wire harness should be made of red primary cable of at least 8 gauge for the F200-2 and at

least 4 gauge for all other larger models. The harness should terminate in a large ring terminal for

connection directly to the positive terminal of the car battery. Use a spade plug to attach the wire,

which connects to the amplier location marked 12V+.

A second black color wire of equal gauge should be used as a ground connection to a welded

chassis member. When connecting the ground wire make sure that there is no paint or other

insulator blocking a good ground connection. When installing multiple ampliers, mount them

in close proximity so that they can all share the same ground point. Attach the black ground wire

to the amplier screw terminal marked Ground.

We recommend that you use the Cadence AMPKIT4 or AMPKIT8 amplier installation kits, which

contains all the cabling and accessories necessary for a good, reliable installation.

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Sin comentarios

Cadence Flash F100-5 Guía de instalación Pagina 7