Cadence Flash F100-5 Guía de instalación descargar pdf (Pagina 25)

F1200-1d TWIN AMPLFIER BRIDGING

Two F1200-1D can be ridged together for double the power output into a 2-ohm load. Though each amp is 1 ohm stable,

when bridging ampliers, you must bridge them to a 2 ohm load.

Input the head unit signal into the MASTER amplier and set the Bridged Mode switch to Master. Use the supplied DATA

CABLE to send the fully processed signal from the MASTER amplier to the secondary SLAVE amplier and set the Bridged

Mode switch to Slave. Do not input any high level or RCA signals into the Slave amplier.

All crossover controls, Bass Drive, frequency settings, and subsonic lter settings will be controlled by the Master Amplier

including input gain levels. There is no need to gain match the two ampliers, it will occur automatically. The remote dash

bass control should be plugged in to the Master amplier and it will control both ampliers.

Make sure to use the supplied DATA CABLE for linking of the ampliers and not the dash board bass remote cable or any

other phone jack cable. If you misplace your cable, contact Cadence or your local dealer to procure a new one.

This same input/control system can be utilized when daisy chaining two ampliers to two independent 1 ohm woofers as

long as you don’t bridge the two ampliers outputs together.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Sin comentarios

Cadence Flash F100-5 Guía de instalación Pagina 25