Cadence PSPICE SCHEMATIC Manual de usuario descargar pdf (Pagina 3)

Figure 2: Dialogue boxes to create a directory for a new project.

1. Select File > New > Project. . . from the menu bar. This brings up the New Project

dialogue box.

2. Select the Analog or Mixed A/D button. This is essential or you will not be able to use

PSpice. (There is no easy remedy if you get this wrong, other than copying your circuit

into a new project.)

3. Create a directory for the new project if you have not done this already. See ﬁgure 2.

• Click on the Browse. . . key, which brings up the Select Directory box.

• Select drive H and navigate to a suitable location.

• Click the Create Dir. . . button, which brings up the Create Directory box.

• Enter a suitable name for a subdirectory, such as potdiv and click OK.

• Double-click on this new directory to select it. In principle the path and new direc-

tory now show in the Location box but in practice the box is too short.

4. Enter a name for the project, such as potdiv (I used the same name as the directory but

you don’t have to do this).

5. Click on OK in the New Project dialogue box to create the project.

6. Select the Create a blank project button in the small dialogue box that appears, shown in

ﬁgure 3 on the following page, and click OK.

This should open a Schematics window as shown in ﬁgure 4 on page 5.

1 2 3 4 5 6 7 8 ... 24 25

Sin comentarios

Cadence PSPICE SCHEMATIC Manual de usuario Pagina 3