Cadence PSPICE SCHEMATIC Manual de usuario descargar pdf (Pagina 10)

Place voltage markers on each side of the resistor. Name the nodes Vin and Vout. Run the simulation

and the results window should appear. Click the Toggle Cursor button and left click the colored dot for

Vout in the legend. Use the mouse to drag the cursor over to the second peak of Vout and note the

amplitude. It should be 3dB smaller than the peak voltage of Vin (0.707V). Click on the Mark Label

button to label the point.

AC Analysis

Close the simulation and modify the circuit, replacing the VSIN source with a VAC source. Leave the new

source with the default attributes. Configure a new simulation profile with name AC. Set the analysis

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Sin comentarios

Cadence PSPICE SCHEMATIC Manual de usuario Pagina 10