Cadence MONO CLASS D Guía de instalación

SMART AMP SERIES // OWNERS MANUAL

17 182 CHANNEL AMPLIFIER 2 OHM / 4 OHM STEREO 2 CHANNEL AMPLIFIER 4 OHM BRIDGED4 Ω BRIDGEDREMCH2 CH1CH4 CH3POWERSPEAKER4 Ω BRIDGEDREMCH2 CH1CH4 CH3P

19 20CLASS D MONO BLOCK 1 OHM AMPLIFIERSPEAKER1 Ω MINIMUMREMPOWERThe D800, D1800M and D2500M are 1 ohm mono block Class D ampliers. No matter

21 22D800MRLINPUTBASSREMOTEMASTERSLAVE 1SLAVE 2SLAVE 1-2 OUT SLAVE 1-2 IN250Hz50Hz15Hz 50Hz0.2V7V0dB0 18012dBGAINF REQUENCYLPFBASS FOCUSBASS BOOSTPHAS

23 24SPEAKER1 Ω MINIMUMREMPOWERSPEAKER1 Ω MINIMUMREMPOWERWhen bridging two D1800M OR D2500M ampliers together, the nal impedance load of the bridg

25 26D800MRLINPUTBASSREMOTEMASTERSLAVE 1SLAVE 2SLAVE 1-2 OUT SLAVE 1-2 IN250Hz50Hz15Hz 50Hz0.2V7V0dB0 18012dBGAINF REQUENCYLPFBASS FOCUSBASS BOOSTPHAS

27 28SPECIFICATIONS NOTES• RATED POWER: 100 WATTS RMS @ 4 OHM x 4• RATED POWER: 150 WATTS RMS @ 2 OHM x 2• MAXIMUM RMS POWER: 300W x 2 @ 4 OHM MONO BR

2 X DUAL VC 2 OHM SPEAKERS WITH SERIES VOICE COILS, ALL IN PARALLELPARALLEL:DUAL VOICE COIL SPEAKERS29 304 X DUAL VC 8 OHM SPEAKERS WITH SERIES VOICE

// Due to constant product improvements, these specifications are subject to change without notice.Though we tried our best to insure that this manual

FEATURES2Thank you for purchasing this Cadence ZRS Smart Amp Series amplier. Over the years, the technology used to create audio ampliers has grown

2FEATURES343GOLD PLATED TERMINALS:All the terminals on the amplier are solid brass and gold plated for high conductivity and minimum impedance loss.

6BATTERY VOLTAGE:Cadence ZRS Smart Series ampliers are rated and regulated to 13.8 volts and below. Increasing voltage to 14.4 volts will increa

SPEAKER1 Ω MINIMUMREMPOWER7 8ADJUSTING THE SYSTEM Once the system is operational, the rst thing to do, is set all crossover points to approximate se

9 10If your head unit has only one pair of Left and Right RCA out put jacks, plug them in to RCA input Jacks 1 and 2 of the amplier and set the Inp

4 Ω BRIDGEDREMCH2 CH1CH4 CH3POWERSPEAKER1112Install any combination of speakers independently on all 4 channels being careful not to load any sin

4 Ω BRIDGEDREMCH2 CH1CH4 CH3POWERSPEAKER13 14Channels 1 and 2 should be wired to speakers no lower than 2 ohm loads per channel in stereo. Channel 3

4 Ω BRIDGEDREMCH2 CH1CH4 CH3POWERSPEAKER15 16COMPONENT VALUES FOR6dB PASSIVE CROSSOVER FREQUENCY INDUCTOR CAPACITOR80 Hz100 Hz1